![]() ![]() Replacement radiator caps should have the same pressure rating as the original on a stock cooling system. But the cap pressure depends on the application and the strength of the radiator, heater core and other components. A 15 PSI cap can raise the boiling temperature as much as 45 degrees over an unpressurized system. The cap seals the system and acts like a pressure cooker to prevent steam from forming. Pressurizing the cooling system with a 8 to 15 PSI radiator cap will raise the boiling temperature of the coolant whether it is straight water or a standard antifreeze/water mixture. That might cause the engine to run too hot and overheat if the cooling capacity of the radiator is marginal (which is often the case with many late-model vehicles that have relatively small radiators and cooling capacities). But a 70/30 mixture of antifreeze and water will not conduct heat as efficiently as a 50/50 mixture because the thermal capacity of antifreeze is not as high as water. A 70/30 mix will lower the freezing point to -67 degrees F and to raise the boiling temperature to 235 degrees F. In some situations, the ratio of antifreeze in the coolant can be increased to as much as 70 percent. A gallon jug also is less expensive than a gallon of straight antifreeze. Most consumers find premixed antifreeze is much more convenient to use because it doesn’t require any mixing. Premixed antifreeze is 50/50 and takes the guesswork out of correctly mixing antifreeze and water. That’s not forever, but long enough to minimize the need for regular coolant changes.Ī 50/50 mixture of antifreeze and water is the standard recommendation for most applications because it provides the best all-round cooling protection and performance for most applications. The additive package in most long-life coolants will last up to 5 years or 150,000 miles. Antifreeze also includes corrosion inhibitors to protect the engine and cooling system against rust and corrosion. When mixed in equal parts with water (50/50), antifreeze lowers the freezing point to -35 degrees F and raises the boiling temperature to 223 degrees F. It also provides no lubrication for the water pump seal and shaft bearing without additives. Straight water cools well, but provides no protection against rust or corrosion without corrosion inhibiting additives. NASCAR and drag cars usually run straight water in their cooling systems, but only because track rules designed to keep slippery ethylene glycol off the track in the event of a coolant spill. But straight water freezes at 32 degrees F and boils at 212 degrees F, which is not adequate for year-round driving or today’s hot running engines. Water is an efficient conductor of heat, which is good for cooling the engine and transferring heat to the radiator and heater core. ![]() So, before using you have to dilute it with water, which is now called the coolant. Antifreeze is a concentrated glycol-based product. Antifreeze is mixed in equal parts with water to create a coolant solution that provides both freezing and boilover protection compared to straight water. Antifreeze and engine coolant are similar, but they are not the same. ![]()
0 Comments
Leave a Reply. |